Mobile Site
  • My Cart

    Your cart is empty

    You have no items in your shopping cart.

EARTHQUAKER AVALANCHE RUN STEREO DELAY & REVERB W/TAP TEMPO

Be the first to review this product

Each and every Avalanche Run is completely assembled, wired and tested by total human beans in the tiny tundra town of Akron, Ohio.

Regular Price: Rp 5,490,000

Now only: Rp 4,392,000

With this product, you earn 65 MG Reward Points.

 

EARTHQUAKER AVALANCHE RUN STEREO DELAY & REVERB W/TAP TEMPO Zoom

Details

Controls

TOP ROW

Time: This controls the delay time and goes from 0ms to just under 2000ms.

Repeats: Controls the regeneration of the delay, from zero repeats to near infinite.

Tone: Controls the tone for the delay line only. Roll off highs to the left, roll off lows to the right and get a flat response in the middle.

Mix: The is the volume control for the delay line. This blends in the wet with dry until 1 o’clock, 1 o’clock to 3 o’clock boosts the wet signal over the dry and 3 o’clock up brings down dry until it is fully wet when all the way up.

BOTTOM ROW

Expression Jack Assign Switch: Use this switch to map the expression jack to one of the assigned controls.

  • Decay- Controls the reverb decay length
  • R Mix- Controls the reverb mix
  • Time- This takes over for the delay time control and is DRASTICALLY different than the interface control. Using the expression pedal to control the time will give you all kinds of wild effects that can not be achieved by turning the knob.
  • Repeats- Controls the delay repeats
  • D Mix- Controls the delay mix
  • Toggle- This takes over for the toggle switch and will cross  fade from forward delay in heel down position to reversedelay in toe down position.

Decay: Controls the decay length of the reverb, short decay counterclockwise, long cavernous decay clockwise.

Mix: This is the volume control for the reverb. Blends in the wet with dry until 1 O’clock, 1 O’clock to 3 O’clock boosts the wet signal over the dry and 3 O’clock up brings down dry until it is fully wet when all the way up.

Ratio Selector Switch: Selects delay subdivisions when time is set by the “Tap” switch.

  • 1/1- Quarter Note
  • 3/4- Dotted 8th
  • 2/3- Quarter Note Triplet
  • 1/2- 8th Note
  • 1/3- 8th Note Triplet
  • 1/4- 16th Note

TOGGLE SWITCH (MODE SELECTOR)

Both: This is the “standard” delay and reverb mode

Reverse: This is reverse delay mode with “standard” reverb

Swell: This is the volume swell mode

Measures

4.625″ x 3.7″ x 2.25″ with knobs

Power

Our pedals take a standard 9 volt DC power supply with a 2.1mm negative center barrel. We always recommend pedal-specific, transformer-isolated wall-wart power supplies or multiple isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power. Switching-type power supplies, daisy chains and non-pedal specific power supplies do not filter dirty power as well and let through unwanted noise. Do not run at higher voltages!

Current draw is 425 mA.

Write Your Own Review

Only registered users can write reviews. Please, log in or register

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.